Next Register (NR4) – Battery Replacement Guide

Next Register (NR4) – Battery Replacement Guide

This article explains how to replace the battery in a Next Register (NR4) device. Follow the steps below to safely remove and install the battery.


Battery Replacement Instructions

  1. Remove the Battery Cap
    Use a large screwdriver to loosen the battery cap.
    Rotate the cap
    counterclockwise to remove it.

  2. Remove the Battery
    Pull the battery straight out from the compartment.

  3. Disconnect the Battery Connector
    Carefully unplug the connector attached to the old battery.

  4. Connect the New Battery
    Insert the connector from the new battery into the device.

  5. Reinsert the Battery
    Place the new battery back into the battery compartment.

  6. Reinstall the Battery Cap
    Position the battery cap back onto the unit and rotate it
    clockwise.
    Continue rotating until the
    alignment arrows meet, indicating the cap is fully secured.


    • Related Articles

    • TR4 Transceiver Battery Replacement Guide

      TR4 Transceiver Battery Replacement Guide This article provides a guide for replacing the battery in your TR4 Transceiver. Overview The battery you will be replacing is the large blue cylinder located on the left side of the TR4 Transceiver, ...
    • Replace Battery - Next Century TR201 Transceiver

      How to Replace the Battery in a Next Century TR201 Transmitter Replacing the battery in your TR201 transmitter is a straightforward process that you can complete in just a few steps. By following these steps, you can easily replace the battery in ...
    • Next Century TR4 Transmitter Wiring & Troubleshooting Guide (Pulse)

      TR4 Transmitter Wiring & Troubleshooting Guide This guide provides clear, step‑by‑step instructions for opening, wiring, and resetting a Next Century TR4 transmitter, along with next steps if additional help is needed. Step 1: Open the Transmitter ...
    • Next Century - Transmitter(s) Offline

      Next Century Troubleshooting Offline Transmitter(s) OVERVIEW: The Next Century transceivers have 2-way communication in the form of an LED status light on the inside of the device. This will change color based on if the transceiver can talk with the ...
    • Connecting the Next Century Gateway to the Internet (Wi-Fi)

      Connecting Your Next Century Gateway to the Internet This guide provides instructions for connecting your Next Century Gateway to the internet using the mobile application. Section 1: Connecting the Next Century Gateway to the Internet The Next ...