How to Correctly Install Wiring for TR4 (Pulse)
Introduction
Proper wiring installation is crucial for the correct operation of your transmitters. Incorrect wiring can lead to malfunction and inaccurate reporting. This guide will walk you through the steps to correctly install the wiring in your transmitter.
Step-by-Step Instructions
Tools Required
- Small Phillip's Screwdriver
Identifying the Issue
Upon reviewing the provided photo, it's clear that the wiring is incorrectly installed. The wires should be connected to the IN and GND ports. Currently, they are inserted into the OUT and IN ports, causing the transmitters to not report any usage.
Correcting the Wiring
Remove the BLUE BLOCK from the Transmitter:
- Lift the BLUE BLOCK up to detach it from the transmitter. This can be done easily without any tools.
- Lift the BLUE BLOCK up to detach it from the transmitter. This can be done easily without any tools.
Unscrew the Wiring:
- Use the small screws on the BLUE BLOCK to remove the incorrectly installed wires.
Reinsert the Wiring into the Correct Ports:
- Insert the wires into the IN and GND ports on the BLUE BLOCK.
- Tighten the screws to secure the wires in place.
Reattach the BLUE BLOCK to the Transmitter:
- Place the BLUE BLOCK back into the transmitter.
- Press the RED button once to get the transmitter to check-in to the gateway.
Final Steps
This process must be repeated for all transmitters to ensure proper functionality. Once you have completed these steps for all transmitters, please inform me so I can verify that the transmitters are checking in correctly.
Troubleshooting Tips
- Ensure that the wires are securely tightened in the IN and GND ports to avoid any loose connections.
- If the transmitter still does not report usage after following these steps, double-check the wiring and ensure the BLUE BLOCK is properly attached.
Conclusion
Proper wiring is essential for the accurate operation of your transmitters. By following these simple steps, you can correct the wiring and ensure your transmitters function correctly. If you encounter any issues or need further assistance, please do not hesitate to contact us using the following link.
Related Articles
How to Use a Multimeter to Check if a Water Meter is Providing Pulses (Using the Continuity Setting)
Introduction Using a multimeter to check if your water meter is providing pulses is a straightforward process. This guide will walk you through the steps to check the pulses using the continuity setting on your multimeter. Tools Required Digital ...