Changing Master Meter Pulse Rings
Hello,
In order to change a pulse ring on the meter you will need to break the tabs on the original ring which can not be used afterwards.
*The portion selected has a magnet underneath the plastic to read the pulses produced by the meter. THIS NEEDS TO BE PLACED BACK IN THE SAME POSITION WHEN RE-ATTACHING THE NEW PULSE RING.
First locate the meter and take a flat head screw driver and separate the pulse ring from the meter.
Pry the pulse ring from the meter by inserting a flat-head screw driver within the following ridge around the entire meter.
Once the pulse ring is removed from the meter locate the new pulse ring.
*Pulse Ring removed from Meter
*New Pulse Ring
When installing the new pulse meter make sure the magnet goes back on the correct side of the meter like displayed above and insert the clip into the following hole:
Pay attention to the direction you place the new pulse ring onto the meter.
*The following photos above show the clip and the proper hole to place it inside of.
If you have any additional questions please don't hesitate to ask.
Related Articles
Meter Inaccuracy - Bucket Test (Pulse Ring)
All Systems Troubleshooting Inaccurate Meter Reads Bucket Test (Pulse Ring): Required Items: 5 Gallon Bucket Voltmeter with oHms setting and/or Continuity Setting Before starting, make sure all water is turned off in the unit so no other water will ...Meter Inaccuracy - Bucket test (Direct Read)
All Systems Troubleshooting Inaccurate Meter Reads Bucket Test (Direct Read): Required Items: 5 Gallon Bucket Before starting, make sure all water is turned off in the unit so no other water will be tracked while testing. Using a 5 gallon bucket, ...How Do Pulse Meters Work?
*** This article applies to all types of meters - water, gas, and electric - but for the sake of simplicity, all explanations are in reference to water meters reading US gallons. Pulse meters record usage by generating electrical pulses that say, "I ...How to Use a Multimeter to Check if a Water Meter is Providing Pulses (Using the Continuity Setting)
Introduction Using a multimeter to check if your water meter is providing pulses is a straightforward process. This guide will walk you through the steps to check the pulses using the continuity setting on your multimeter. Tools Required Digital ...Plugging in a FAM Reed Switch - Ensure Reed Switch is Seated on Meter Face